Philips AZ5836 - Manual (Page 11)

11
English
Preparations
Setting the TV set
IMPORTANT!
– Make sure you have completed all the
necessary connections.
1
Press SOURCE repeatedly on the set or press
DISC
on the remote control to select disc mode.
2
Turn on the TV set and set to the correct Video-
In channel. You should see the blue Philips DVD
background screen on the TV set.
➜ You may go to channel 1 on your TV set, then
press the channel down button repeatedly until
you see the Video In channel.
➜ Or, you can use the TV remote control to
select different video modes.
➜ Or, set TV to channel 3 or 4 if you are using
an RF modulator.
Selecting the color system that matches
your TV set
This DVD Soundmachine is compatible with
both NTSC and PAL. For the playback of a DVD
disc on this DVD Soundmachine, the color
systems of the DVD, TV set and DVD
Soundmachine should match.
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Before using the remote control
1
Pull out the plastic protective sheet.
2
Select the source you wish to control by pressing
one of the source select keys on the remote
control (for example DISC, TUNER).
3
Then select the desired function (for example
ЙЕ, а, б).
Replacing battery (lithium
CR2025) into the remote control
1
Press the slot on the battery compartment.
2
Pull out the battery compartment.
3
Replace a new battery and fully insert the
battery compartment back to the original
position.
1
2
3
CR2025
CAUTION!
Batteries contain chemical substances, so
they should be disposed of properly.
Remove the plastic protective sheet
1
2
AZ5836_58_P01-31_Eng 2008.3.13, 10:29 11