Paradyne 3161-B3 - Manual (Page 62)

3. Operation
3-28 February 2001 3160-A2-GB21-90
Configuring a Destination for SNMP Traps
A destination must be configured for each SNMP trap manager specified. This
configuration option is displayed for the number of trap managers specified by the
Number of Trap Managers configuration option.
Procedure
To configure an IP address for the SNMP trap manager:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the key until the Mgmt selection appears on
the screen.
5. Select Mgmt.
6. From the Mgmt Config screen, select Trap.
7. Press F1 (Next) until the Trapn IP Address configuration option appears.
8. Press F2 (Edit) to edit the IP address. You have the option of using F3 (Clear)
to reset the IP address to the factory default 000.000.000.000. Refer to Setting
the IP Address on page 3-21 for more information on setting an IP address.
9. Press F1 (Next) until the Trapn Destination configuration appears, and select
the destination for the SNMP trap by using the appropriate Function key. Use
the scroll keys, if necessary.
F1 F2 F3
Edit:
User Alarm Mgmt
F1 F2 F3
Mgmt Config:
Gen Trap
F1 F2 F3
Trapn Dst:
Next None Com