Paradyne 3161-B3 - Manual (Page 238)

E. SNMP MIB Objects
E-24 February 2001 3160-A2-GB21-90
Output Signal Table, RS-232-like MIB
This object contains entries for the output signals that can be asserted by the unit
for each of the synchronous data ports.
Output Signal Table – “rs232OutSigName” (rs232OutSigEntry 2)
This object contains the identification of a hardware output signal. Only the
following values are supported by the DSU/CSU.
T cts(1) – Clear-To-Send.
T dsr(4) – Data Set Ready.
Output Signal Table – “rs232OutSigState” (rs232OutSigEntry 3)
This object contains the current signal state. Only the following values are
supported by the DSU/CSU.
T on(2) – The signal is asserted.
T off(3) – The signal is not asserted.
Output Signal Table – “rs232OutSigChanges” (rs232OutSigEntry 4)
This object is not supported by the DSU/CSU.
Generic-Interface MIB Extensions (RFC 1229)
This generic-interface MIB is an experimental MIB that provides extensions to the
generic interface group defined in MIB II. This MIB describes three tables:
T Generic Interface Extension Table
T Generic Interface Test Table
T Generic Receive Address Table
Only the generic interface test table is supported by the DSU/CSU. This table is
supported for the network interface only.