Philips DA1102 - Manual (Page 6)

DA11 Quickstart Guide
2
Quickstart Guide- Settings and Operation
The DA11 front panel has three sections: (Diagram 1)
There are two main modes for the DA11- the Operating Mode and the Setting mode.
- In Operating mode, the front panel displays the status of the
>PiC< Playback Image
Control in the IMAGE section. The VOLUME display indicates the setting of the volume
control when the volume is adjusted and for approximately 10 seconds afterwards. The
VOLUME display then reverts to displaying “LE.”
- In the Setting mode, the status of settings is displayed along with the position of the
cursor in the IMAGE display section. The position of the cursor is denoted by the LED
flashing. When an active input is selected, the VOLUME display will indicate the sample
rate of the digital audio input. If the input is not “locked” or there is no signal present on
the selected input, the VOLUME display shows the symbol “- -“
- Approximately 10 seconds after exiting the Setting mode, the VOLUME display reverts
to “LE” to indicate that the settings have been stored in a non-volatile memory. This
means the DA11 will retain the settings even if the power is turned “off.” Any time the
VOLUME display reverts to the “LE” symbol, the settings are stored, including after any
volume adjustment from the front panel or remote.
Diagram 1, Section 1- Setting Controls
The two toggle switches on the left side of the front panel under the SELECT legend
control the Setting mode of the DA11.
The first switch labeled with the
symbols has two functions:
- Clicking the switch down while in the operating mode causes the DA11 to enter Setting
mode. The flashing cursor and the indicators for settings that are “on” will appear in the
IMAGE display window
- While in Setting mode, clicking the switch down moves the cursor one position to the
right and clicking the switch up moves the cursor one step to the left.
- The position of the cursor is retained when exiting Setting mode, so the cursor will
appear at the same position it was in when Setting mode is re-entered (in other words,
clicking “set” will turn the same function on and off). The exception occurs when AC
power is first turned “on;” the cursor will always appear in the left-most position (xlr).
The second switch is labeled “exit” and “set.”
- Clicking the switch down (set) toggles the function On and Off. In the case of selecting
an input, the input at the cursor position is enabled and all other inputs are disabled.
- Clicking the switch up (exit) immediately exits the Setting mode.
- After exiting the Setting mode, clicking the switch in either direction has no effect.