Philips DA1102 - Manual (Page 19)

DA11 Operation
15
If you have difficulty determining the correct setting, please contact
[email protected] once you have the manufacturer’s ratings for your
equipment.
OPTIONAL INFRARED REMOTE
The DA11 is programmed to accept standard Philips RC5 TV infrared remote commands. This
means almost any Universal infrared remote control can be programmed to control the DA11. Be
sure to check the information on the universal remote package to confirm it works with Philips
TV’s. Follow the instructions that come with the universal remote, and program the remote using
the code from the instructions for a Philips TV. If the first code does not work correctly, there is
often more than one code available; so try a different code that is also for a Philips TV.
Once the universal remote is programmed, it controls the DA11 in the following manner:
1.) The “Mute” button is always active and immediately toggles the audio outputs of the DA11
“on” and “off.” Please note that this does affect the headphone output and is therefore not the
same as the “output” function in Settings mode.
- To indicate the “mute” function has been engaged, the two LED’s in the IMAGE display will go
dark unit the mute button is pressed again to un-mute the DA11, or the mute function is turned
“off” by operating the DA11’s front panel volume up/down switch.
2.) All other commands are “gated” to prevent accidental changes unless the SAFE MODE is
disabled. The symbol “LE” appears in the VOLUME display to indicate that the gate is “closed”
and the DA11 will not accept infrared commands other than Mute. Press and hold the number “0”
button for a few seconds, and the numerical volume setting will re-appear to indicate that the
“gate is open.” As long as the numerical volume setting is displayed, the DA11 continues to
accept remote commands. Please also note that the “LE” indicates when the settings have been
stored in memory. See DISABLING SAFE MODE (below) to disable the “gating function.”
- Pressing the “Mute” button also “opens the gate;” so it is not necessary to press “0” to access
the other remote functions until the LE symbol appears in the Volume display.
For all of the following functions, it is assumed that the “gate is open” so the numerical
setting is visible in the VOLUME display or that SAFE MODE has been disabled.
3.) To raise or lower the volume setting, press the Volume Up or Volume Down button on the
remote. Similar to the front panel “up/down” switch, a single press of the remote button will
change the volume by one step, and holding the button will make the setting change continuously
until the button is released or the end of the adjustment range has been reached.
4.) The number pad can be used to adjust the >PiC< Playback Image Control™ and control the
“gating” function according to the following chart:
1
Increase width Left channel
2
Increase width both channels
3
Increase width Right channel
4
Decrease width Left channel
5
Decrease width Both channels
6
Decrease width Right channel
7
No function
8
Reset width to “0” (normal)
9
No function
0
Press & Hold to open “gate”