Polycom SpectraLink 1725-36028-001 - Manual (Page 57)

Network Configuration
correct setting from the DHCP server. The DHCP setting is only valid
when the IP address is also acquired using DHCP.
WINS servers : These setting are used for Windows Internet Name
Services. Consult your system administrator for the correct settings.
These can also be set to DHCP. This will cause the DHCP client in the
gateway to attempt to automatically get the correct setting from the
DHCP server. The DHCP setting is only valid when the IP address is
also acquired DHCP.
When the name services are set up correctly, the SpectraLink 8000
Telephony Gateway can translate hostnames to IP addresses.
Using Telnet, it is also possible to access the SpectraLink 8000
Telephony Gateways using their hostname instead of the IP
address.
Logging and Log server : Logging can be set to Syslog or NONE . The log
server is the IP address or hostname of the Syslog server on the
network. The gateway will output syslog format diagnostic messages.
This is usually not needed.
SNTP : The SNTP (Simple Network Time Protocol) server provides a
time stamp for syslog messages. See the Configuration and
Administration document for the SpectraLink Wireless Telephone for
detailed information about syslog messages. If syslog is being used,
then SNTP server should be set to the hostname or IP address of an
SNTP server.
GMT Offset : Difference in hours from Greenwich Mean Time, used for
time stamping by SNTP. There is no automatic adjustment for
Daylight Savings Time. Enter –0 to –12 for zones that are earlier than
GMT and +0 to +12 for zones that are later than GMT. Example:
Mountain Standard Time is –7, or –6 during DST.
SNMP : Simple Network Management Protocol: Enter the IP address of
the SNMP server to allow alarms and other simple events to be sent
from the SpectraLink 8000 Gateway to the SNMP server. More
specific configuration information is not sent.
IGMP : Internet Group Management Protocol: Yes enables, No disables.
This is used for managing multicast traffic. It should typically be set
to
Yes .
Maintenance Lock : The system automatically sets this option to Yes
after certain maintenance activities that require reset. These are
indicated in this list with an arrow bullet. Maintenance Lock prevents
any new calls from starting. Note that the administrator cannot
change this option. It is automatically set by the system. Reset the
system at exit to clear Maintenance Lock.
PN: 1725-36028-001_T.doc 57