Philips C922 - Manual (Page 7)

5
Charger
Installation
To operate the charger you will
need a mains connection with
230 V alternating current. To
use the charger as a desktop
installation, attach the stand to
the charger by inserting it in
the holes provided at the rear
of the charger, and then slide
it into place.
For a wall installation, install
two screws, max. dia. 4 mm, in
the wall at a distance of 34 mm
from each other. Make sure
that the screw heads protrude
by 2.5 to 3 mm. Finally, hang
the charger on the screws.
Connect the power supply
cable to the connector at the side of the charger, then plug the
AC adapter into the mains socket.
Important Battery Information
Note: Only use the battery for its specifically intended pur-
pose. Never use a battery which is damaged or exhausted.
Heat or cold reduce the capacity and life of the battery. The
environmental operating temperature should be between 15
and 25 degrees Celsius. A handset which has a hot or cold
battery can be temporarily out of operation, even if the battery
is fully charged.
Dispose of exhausted batteries in accordance with local authority
regulations. Where possible, hand them in for recycling.
Do not throw the batteries in a fire.
34 mm