Planet Technology GRT-101 - Manual (Page 73)

PLANET Technology Corp. GRT-101/401 User ’s Manual
- - 68
Connecting...
Download
Byte Transferred : 624641 bytes
Complete
Transfer Complete, Replace Now? (y/n): y
Writing flash....................... OK!
Do you want to reboot? (y/n): y
Be sure to write the new image to NVRAM and immediately reboot the device
to activate it. When you log back onto GRT-101/GRT-401 after the reboot,
then you can use the
“show system” command to verify the version of the new
firmware that is active, and restore your configuration.
Note: All configurations will be cleared during the upgrading procedure. Make sure that you have a backup
configuration file before you start the upgrading procedure. See section 3.17.1 Backup configuration for details.