Planet Technology GRT-101 - Manual (Page 47)

PLANET Technology Corp. GRT-101/401 User ’s Manual
- - 42
3.8 Setup
All of the setup parameters are located in the subdirectories of setup. Move the
cursor
“ >> “ to setup and press enter.
>> mode Switch system operation mode
shdsl Configure SHDSL parameters
wan Configure WAN interface profile
bridge Configure transparent bridging
route Configure routing parameters
lan Configure LAN interface profile
ip_share Configure NAT/PAT parameters
dhcp Configure DHCP parameters
dns_proxy Configure DNS proxy parameters
hostname Configure local host name
default Restore factory default setting
3.8.1 Mode
The product can act as routing mode or bridging mode. The default setting is
routing mode. You can change the system operation mode by using mode
command. Move the cursor
“ >> “ to mode and press enter.
---------------------------------------------------------------------
Command: setup mode
Message: Please input the following information.
System operation mode (TAB select) : Route
---------------------------------------------------------------------
3.8.2 SHDSL
You can setup the SHDSL parameters by the command shdsl. Move the
cursor
“ >> “ to shdsl and press enter.
>> mode Configure SHDSL mode
n*64 Configure SHDSL data rate
type Configure SHDSL annex type
clear Clear current CRC error count
margin Configure SHDSL SNR margin
There are two types of SHDSL mode, STU-R and STU-C. STU-R means the
terminal of central office and STU-C customer premises equipment.
You can setup the data rate by the multiple of 64Kbps- n is from 0 to 32. If you