Planet Technology GRT-101 - Manual (Page 14)

PLANET Technology Corp. GRT-101/401 User ’s Manual
- - 9
After you logon to GRT-101/GRT-401 and before proceeding any further,
check the software version of GRT-101/GRT-401 by the command:
admin> show system
If firmware file is downloaded from our local distributor or FTP server, please
refer to TFTP command in the section 3.18 Software Upgrade for more
information on how to update GRT-101/GRT-401 firmware.
3.2.2 Telnet
Make sure the correct Ethernet cable is used for connecting the LAN port of
your computer to GRT-101/GRT-401. The LAN LNK indicator on the front
panel shall light if a correct cable is used. Starting your Telnet client with VT100
terminal emulation and connecting to the management IP of
GRT-101/GRT-401, wait for the login screen appears. When you see the login
screen, you can logon to GRT-101/GRT-401.
User: admin
Password: *****
Note: The factory default management IP and subnet mask are of 192.168.0.1 and 255.255.255.0, respectively. To
change these setting, see section 3.10.1 Bridge management and 3.11.1 LAN setting for routing mode operation. If
you have not set any user profile for GRT-101/GRT-401, enter the factory default user “admin”. When the system
prompts you for a password, type “admin” to enter GRT-101/GRT-401. For more security issues for remote
management interfaces such as Telnet and web interface, see section 3.15 Management Security.
3.2.3 Web browser
Make sure the correct Ethernet cable is used for connecting the LAN port of
your computer to GRT-101/GRT-401. The LAN LNK indicator on the front
panel shall light if a correct cable is used. Starting your web browser and
connecting to the management IP of GRT-101/GRT-401, wait for the login
screen appears. When you see the login screen, you can logon to
GRT-101/GRT-401.
Note: The factory default management IP and subnet mask are 192.168.0.1 and 255.255.255.0 respectively. To
change these setting, see section 3.10.1 Bridge management and 3.11.1 LAN setting. If you have not change
password setting for web interface, enter the factory default user “root”. When GRT prompts you for a password, type