Polycom RMX DOC2560B - Manual (Page 44)

Chapter 2-First Time Installation and Configuration
2-12
Installing the RMX 2000
• The following procedures have to be performed to install the RMX
2000 in your site:
• Installing the RMX in a rack or as a standalone
• Connecting the RMX 2000 to the power source
• Connecting the network (LAN, IP and ISDN) cables to the RMX
Mounting the RMX 2000 in a Rack
There are two methods for installing the RMX in a 19” rack:
•
Using rack brackets on the RMX 2000– Install rack brackets,
supplied by the rack manufacturer, in the rack. Mount the RMX 2000
on top of the rack brackets. Fasten the RMX to the rack with screws
through the four holes in the RMX’s front mounting brackets.
• Using a shelf – Install the shelf, supplied by the rack manufacturer,
in the rack. Mount the RMX on the shelf. Fasten the RMX to the rack
with screws through the four holes in the RMX’s front mounting
brackets.
For detailed instructions, precautions and requirements for installing the RMX
2000 refer to the Polycom RMX 2000 Hardware Guide.