Polycom RMX DOC2560B - Manual (Page 35)

Polycom RMX 1500/2000/4000 Getting Started Guide
2-3
IP Network Services Required Information
When installing an RMX unit, these default IP addresses must be
modified to your local network settings. Therefore it is important that
before powering the RMX unit up for the first time, that you obtain the
information needed to complete the Local Network Settings section of
the table from your network administrator.
For RMX 1500, the network administrator should allocate three IP
addresses in the local network for an MCU with a MPMx card.
For RMX 2000, the network administrator should allocate four IP
addresses in the local network for an MCU with one MPM/MPM+/MPMx
card and five IP addresses for an MCU with two MPM/MPM+/MPMx
cards.
For RMX 4000, the network administrator should allocate four IP
addresses in the local network for an MCU with one MPM+/MPMx card
and up to seven IP addresses for an MCU with up to four MPM+/MPMx
cards.
Table 2-1 Network Equipment and Address Information
Parameter Factory Default Local Network Settings
Control Unit
IP Address 192.168.1.254
Control Unit
Subnet Mask 255.255.255.0
Default Router IP
Address 192.168.1.1
Shelf Management IP
Address 192.168.1.252
Signaling Host IP
address
–
Media Board IP
address (MPM 1)
–
Media Board IP
address (MPM 2)
RMX 2000/4000 only
–