Listening to the radio 21, Tuner, Listening to the radio – Pioneer AVH-P6400 User Manual
Page 21
Tuner
En
21
Listening to the radio
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on page 22.
1
BAND
indicator
Shows which band the radio is tuned to, AM
or FM.
2
FREQUENCY
indicator
Shows to which frequency the tuner is
tuned.
3
STEREO
(
ST
) indicator
Shows that the frequency selected is being
broadcast in stereo.
4
PRESET NUMBER
indicator
Shows what preset has been selected.
1 Press
SOURCE
to select the tuner
.
Press
SOURCE
until you see
Tuner
displayed.
2 Use
VOLUME
to adjust the sound level.
Rotate to increase or decrease the volume.
3 Press
BAND/ESC
to select a band
.
Press
BAND/ESC
until the desired band is dis-
played,
FM1
,
FM2
,
FM3
for FM or AM.
4 To perform manual tuning, press
2 or 3
with quick presses.
The frequencies move up or down step by step.
5 To perform seek tuning, press and hold
2
or
3 for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
• You can cancel seek tuning by pressing either
2 or 3 with a quick press.
• If you press and hold
2 or 3 you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
Note
• When the frequency selected is being broad-
cast in stereo the
STEREO (
ST
)
indicator will
light.
English
Espa
ñ
ol
Deutsch
F
ran
ç
ais
Italiano
Nederlands
05
Section
1
2
4
3