Philips HTS8000S - Manual (Page 21)

English
21
3139 115 2xxx1
Getting Started
(continued)
TIPS: The underlined option is the factory default setting.
To return to the previous menu, press
1. To remove the menu, press SETUP MENU.
7
Select { Progressive } > { On }, then
press OK to confirm.
Video Setup Page
TV Type
TV Display
Progressive
Picture Setting
Component
On
Off
8
The below menu will appear on the TV.
HINTS:(refer to the owner's manual)
ACTIVATING PROGRESSIVE:
1. Ensure your TV has progressive scan.
2. Connect with YPbPr(GBR) video cable.
3. If there is a blank screen on normal TV,
wait 15 seconds for auto recover.
Cancel OK
9
Press
1 to highlight
OK in the menu
and press OK to confirm.
There will be no picture on your TV
at this state until you turn on the
progressive scan mode on your TV.
0
Turn on your TV progressive scan mode
(refer to your TV user manual).
➜
The below menu will appear on the TV.
Confirm again to use progressive scan
If picture is good press OK on remote
Cancel OK
!
Press
1 to highlight
OK
in the menu
and press OK to confirm.
➜
The set up is complete now and you
can start enjoy the high quality picture.
If no picture:
●
Wait for 15 seconds for the auto recovery.
OR
1
Deactivate Progressive Scan feature by
pressing the EJECT on the DVD system.
2
Press 1 on the remote.
3
Press SUBTITLE on the remote.
➜
The blue DVD background screen will
appear on the TV.
Helpful Hint:
– There are some progressive scan TV and
High-Definition TV sets that are not fully
compatible with this DVD system, resulting in
the unnatural picture when playing back a
DVD VIDEO disc in the progressive scan
mode. In such a case, turn off the
progressive scan feature on both the DVD
system and your TV set.
001-049 HTS8000S-00-Eng 22/04/2005, 04:05 PM 21