Philips HTS8000S - Manual (Page 14)

14
3139 115 2xxx1
English
Optional Connections
(continued)
IMPORTANT!
– The progressive scan video quality
is only possible when using Y Pb Pr
and a progressive scan TV is required.
– DO NOT connect both SCART
and Y Pb Pr to a TV, it may affect the
picture quality.
1
Use the component video cables (red/
blue / green - not supplied) to connect the
Junction Box’s Y Pb Pr sockets to the
corresponding component video input
sockets (or labelled as Y Pb/Cb Pr /Cr or
YUV) on the TV.
●
Do not connect the SCART from
Junction Box to your TV.
2
To hear the TV channels through this
DVD system, use an audio cables (white /
red - not supplied) to connect AUX IN
sockets to the corresponding AUDIO
OUT sockets on the TV.
3
Proceed to pages 20~21 for detailed
Progressive Scan set up.
Connecting to a Progressive
Scan TV
If the FM reception is poor, you can use
an FM coaxial cable (not supplied) to
connect the FM 75
Ω coaxial cable hidden
inside the back cover directly to the
outdoor FM antenna terminal.
1
Open the main DVD system’s back cover
by lifting up the cover from the bottom.
2
Unplug the FM pigtail antenna from the
FM 75
Ω coaxial cable.
3
Connect the FM 75
Ω coaxial cable to
one end of the FM coaxial cable which is
connected to the outdoor FM antenna
terminal.
Helpful Hint:
– Position the antennas as far as possible
from your TV, VCR or other radiation source
to prevent unwanted interference.
DIGITAL IN L AUX IN R COMPONENT VIDEO
Pr Pb Y
TO SUB-
WOOFER
VIDEO
AUDIO
OUT IN
TV
Junction box
Connecting to outdoor FM
antenna terminal
FM Antenna
3
2
1
1 2
FM pigtail
cable
001-049 HTS8000S-00-Eng 22/04/2005, 04:05 PM 14