Planet Technology VIP-110 - Manual (Page 55)

H.323 Configuration Commands 43
set h323 endpoint_prefix
This command is used to set the H.323 prefix that the ITG uses when registering to an H.323
gatekeeper. After registering to a gatekeeper using the prefix, the gatekeeper will map all
Admission Request with destination matching the prefix to the ITG.
set h323 endpoint_prefix alias
Syntax Description
alias H.323 alias of the prefix.
Factory default
Null
set h323 endpoint_reg_type
When the ITG registers to a gatekeeper, it specifies the H.323 entity type it is registering in
the RRQ message it sends to the gatekeeper. This command is used to set the H.323
registration type. This should not be confused with the H.245 terminal type, although the two
parameters should be programmed consistently.
set h323 endpoint_reg_type {gw | terminal}
Syntax Description
gw The ITG registers itself to gatekeeper as a H.323 Gateway
terminal The ITG registers itself to gatekeeper as a H.323 Terminal
Factory default
gw
set h323 gk_addr
This command is used to specify the address of the default gatekeeper.
set h323 gk_addr ip_addr
Syntax Description
ip_addr IP address of the H.323 gatekeeper
Factory default
0.0.0.0
Related Commands
set h323 gk_name
Once the IP address of the gatekeeper is specified, the host name of the
gatekeeper specified via CLI command set h323 gk_name does not take
effect.
ë
Note