Planet Technology VIP-110 - Manual (Page 25)

IP Configuration Commands 13
net set pppoe {on | off}
This commands enables or disables the PPPoE client.
net set pppoe {on | off}
Syntax description
on Enable PPPoE client
off Disable PPPoE client
Factory default
off
net set pppoe service_name
This commend is used to specify the service name the PPPoE client encapsulates in the PPPoE
Discovery packet it broadcast across the WAN interface.
net set pppoe service_name “service_name”
Syntax description
service_name PPPoE service name, up to 23 characters. If not specified, the
original service name is deleted.
Factory default
“”
net set pppoe tx_bw
The ITG implement a bandwidth regulator over its PPPoE interface. The bandwidth regulator is
enabled, when PPPoE client is enabled, for guaranteeing enough bandwidth is reserved for
voice packets sent across the PPPoE connection. The ITG has to be aware of the maximum
transmission bandwidth the PPPoE link provides for reserving bandwidth for voice packets.
net set pppoe tx_bw kbps
Syntax description
kbps Maximum transmit bandwidth the PPPoE link provides in kbps. If 0
is specified, the bandwidth regulation algorithm is disabled.
Factory default
0
net set pppoe user
This commend is used to specify the user name and password for the PPPoE client.
net set pppoe user “name” “password”
Syntax description
name PPPoE client user name. Up to 63 characters.