Planet Technology VIP-110 - Manual (Page 36)

Telephony Interface Port Configuration Commands 24
set port_cfg tone_out_on milliseconds
Syntax description
milliseconds Value is milliseconds, ranging from 0 to 65535.
Factory default
200 ms
Related Commands
set port_cfg tone_out_off
set port_cfg tone_out_pwr
set port_cfg tone_out_pwr
This command is used to set the power level for DTMF tones generated by the ITG.
set port_cfg tone_out_pwr power
Syntax description
power Power level of DTMF tones in 0.1 dBm.
Factory default
-60. The factory setting for DTMF tone power for all telephony ports is –6.0 dBm.
Related Commands
set port_cfg tone_out_on
set port_cfg tone_out_off
set port_cfg txgain
After decompressing a voice packet, the ITG adjusts the signal level of the voice stream
before sending the signal toward the telephony port. This command allows user to specify the
gain level for PCM signal before feeding the signal to a telephony port.
set port_cfg txgain db
Syntax description
db Gain level in dB, ranging from –14 to 14.
Factory default
0
Related Command
set port_cfg rxgain
set port_cfg voice_prof
This command is used to select the preferred voice coding profile for a telephony port. Please
refer to 5. Voice and Fax Coder Configuration
Commands