Planet Technology VIP-110 - Manual (Page 22)

IP Configuration Commands 10
Factory default
255.255.0.0
Related Commands
net set wan ip
net show wan
This command displays the WAN interface parameters
net show wan
Syntax description
This command has no arguments or keywords
Configuring DHCP Server and Client
The ITG implements a DHCP server over its LAN interface and a DHCP client over its WAN
interface. This section describes commands for setting and displaying parameters for DHCP
server and client.
net set dhcp client
The ITG supports DHCP client over its WAN interface for obtaining IP configuration from a
remote DHCP server.
The net set dhcp client command allows you to configure the DHCP client.
net set dhcp client {on | off}
Syntax description
on Enable DHCP client over WAN interface
off Disable DHCP client
Factory default
off
net set dhcp mac_addr
Certain DHCP server allows DHCP client to request IP configuration only if predefined
hardware address is specified by the client.
The net set dhcp mac_addr command allows you to specify the hardware address for the
DHCP client. If not specified, the ITG will use the MAC address of the WAN interface.
net set dhcp mac_addr mac_addr
Syntax description
mac_addr The 6-byte, in hexadecimal format, hardware address for the
DHCP client. Each byte, except the least significant one, should be
delimited by a hyphen (“-”). If not specified, the ITG will use the