Pioneer VSX-D811S - Manual (Page 51)

Controlling the rest of your system 09
51
En
4 Point the two remote controls towards
each other about 1-2 inches apart then
press the button that will be doing the
learning on this receiver’s remote control
(for example
3, 7, etc.).
The LED flashes rapidly.
1 - 2 inches
TV TVFUNC MENU
VOLUME
MASTER VOLUME
TV CONTROL AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT
CHANNEL ENTER
ENTER DISC
DTV INFO
MPX/RETURN
DTV ON/OFF
DTV MENU
D.ACCESS
GUIDE
ST
TUNE TUNE
ST
CLASS
AT T
BAND /DTS
DSP
TEST T ONE
CH SELECT
CH LEVEL
FUNCTION SIGNAL SELECT
1¡
4
¢
7
8
3
¶
EFFECT
DVD
V CR
CD-R
TV
RCV
TUN
TVC
CD
MIDNIGHT LOUDNESS
MUTING
SETUP
FL DIMMER MUL TI CONTROL 5.1 / 7.1
RECEIVER
SOURCE 1
2
3
4
5
6
7
8
9
0
10 2
5 Press the corresponding button on the
other remote control that is sending
(teaching) the signal to this receiver’s
remote control (for example
3, 7, etc.).
If the operation has been learned successfully,
the LED on this receiver’s remote will go out
and then light steadily.
If for some reason the operation hasn’t been
learned the LED will blink for three seconds and
then light steadily. If this happens, keep
pressing the (teaching) button as you vary the
distance between the two remotes, until you
see the the LED light steadily.
To program additional operations for the current
component repeat steps 4 and 5.
To program operations for another component
exit and repeat steps 1 through 5.
6 Press and hold the REMOTE SETUP
button for three seconds to store the
operation(s).
• Some commands from other remote
controls cannot be learned, but in most
cases the remotes just need to be moved
closer together or farther apart.
• Certain buttons represent operations that
cannot be learned from other remote
controls. These include:
RECEIVER ,
REMOTE SETUP and the MULTI
CONTROL, RECEIVER CONTROL and
MASTER VOLUME buttons.
• TV CONTROL buttons (TV , TV VOL +/-,
and
TV INPUT) can only be learned after
selecting TV or TVC.
Erasing one of the remote
control button settings
(VSX-D811S only)
This erases one of the buttons you have
programmed and restores the button to the
factory default.
1 Press REMOTE SETUP and hold for three
seconds.
The LED lights steadily for two seconds.
2 Press the MULTI CONTROL button
relating to the button setting to be erased.
3 Prepare the remote to erase the button
setting.
Press the
RECEIVER button twice quickly.
The LED blinks to indicate the remote is ready
to erase the button setting.
4 Press and hold the button to be erased
for three seconds.
The LED lights steadily for three seconds and
then goes off.
5 Repeat step 4 to erase other buttons.
6 Press and hold the REMOTE SETUP
button for two seconds to exit.
Clearing all the remote
control settings
You can clear all presets and restore the factory
default settings.
1 Press REMOTE SETUP and hold for three
seconds.
The LED lights steadily for two seconds.
XRB3013A.49.67 01.12.12, 4:49 PM 51