Pioneer VSX-D811S - Manual (Page 44)

Setting up the receiver 06
44
En
Setting the relative volume level
of each channel
• Default setting: 0db
For best surround sound playback, you should
set the relative channel levels from the main
listening position. You can set seperate levels
for each surround mode.
1 Press RCV.
2 Press TEST TONE to output the test
tone.
The test tone is output in the following order
(depending on the speaker setting):
FL C
SR
FR
SL SW SB*
*VSX-D811S only
If you don’t hear a test tone from one of your
speakers, please refer to Speaker setting on
page 39 to make sure you have correctly
specified your speaker setup.
3 Press MASTER VOLUME +/– to adjust
the volume to an appropriate level.
4 Use LEVEL +/- to adjust the speaker
levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level range
is ± 10 dB.
5 When you’re done, press TEST TONE to
turn off the test tone.
The speaker volume can be adjusted without
outputting the test tone by pressing CH
SELECT and then using LEVEL +/–.
TV
TV INPUT
MENU
TV VOL MASTER VOLUME
TV CONTROL
AV PRE-PROGRAMMED
REMOTE CONTROL UNIT
CHANNEL
ENTER
ENTER
MPX/RETURN DTV INFO
DTV ON/OFF DTV MENU
D.ACCESS T.EDIT/GUIDE
ST
TUNE
T P SE U
TUNE
ST
CLASS
FL DIMMER
BAND
TOP MENU AUDIO SUB TITLE
REMOTE SETUP
RECEIVER CONTROL
STANDARD ADV.SURR. STEREO
ANGLE
1 ¡ 4 ¢
7 8 3 ¶
LEVEL
DVD VCR CD-R TV
RCV TUN TVC CD
TEST TONE
CH SELECT
INPUT ATT
INPUT SEL. MUTE MIDNIGHT/ LOUDNESS SIGNAL SEL
MULTI CONTROL
EFFECT DISPLAY DISC +10
RECEIVER SOURCE
1 2 3
4 5 6
7 8 9
0
• Test tone is only output in Standard
modes.
• Since the subwoofer transmits an ultra-
low frequency its sound may seem
quieter than it actually is.
XRB3013A.38.44 01.12.12, 4:46 PM 44