Pioneer VSX-D811S - Manual (Page 34)

Playing sources 05
34
En
Choosing the input signal
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
CHANNEL
ENTER
ENTER
MPX/RETURN DTV INFO
DTV ON/OFF DTV MENU
D.ACCESS T.EDIT/GUIDE
ST
TUNE
T P SE U
TUNE
ST
CLASS
FL DIMMER
BAND
TOP MENU AUDIO SUB TITLE
REMOTE SETUP
RECEIVER CONTROL
STANDARD ADV.SURR. STEREO
ANGLE
1 ¡ 4 ¢
7 8 3 ¶
LEVEL
DVD VCR CD-R TV
RCV TUN TVC CD
TEST TONE
CH SELECT
INPUT ATT
INPUT SEL. MUTE MIDNIGHT/ LOUDNESS SIGNAL SEL
MULTI CONTROL
EFFECT DISPLAY DISC +10
RECEIVER SOURCE
1 2 3
4 5 6
7 8 9
0
• Press SIGNAL SEL (SIGNAL SELECT) to
select the input signal corresponding to the
source component.
Each press switches between AUTO, DVD 5.1
ch/DVD 7.1ch, ANALOG and DIGITAL. The
default is
AUTO.
DVD 5.1ch (VSX-D711) and DVD 7.1ch (VSX-
D811S) will only appear when
DVD/LD is
selected using the remote or the MULTI JOG/
INPUT SELECTOR dial on the front panel.
When set to DIGITAL, 2 DIGITAL lights when
a Dolby Digital signal is input, and DTS lights
when a DTS signal is input.
• This receiver can only play back Dolby
Digital, PCM (32kHz, 44kHz, 48kHz, and 96
kHz) and DTS digital signal formats. With
other digital signal formats, set to
ANALOG.
• You may get digital noise when a LD or CD
player compatible with DTS is playing an
analog signal. To prevent noise, make the
proper digital connections (page 14) and
set the signal input to
DIGITAL.
• Some DVD players don’t output DTS
signals. For more details, refer to the
instruction manual supplied with your DVD
player.
Listening to multi-channel
playback
CHANNEL
ENTER
ENTER
MPX/RETURN DTV INFO
DTV ON/OFF DTV MENU
D.ACCESS T.EDIT/GUIDE
ST
TUNE
T P SE U
TUNE
ST
CLASS
FL DIMMER
BAND
TOP MENU AUDIO SUB TITLE
REMOTE SETUP
RECEIVER CONTROL
STANDARD ADV.SURR. STEREO
ANGLE
1 ¡ 4 ¢
7 8 3 ¶
LEVEL
DVD VCR CD-R TV
RCV TUN TVC CD
TEST TONE
CH SELECT
INPUT ATT
INPUT SEL. MUTE MIDNIGHT/ LOUDNESS SIGNAL SEL
MULTI CONTROL
EFFECT DISPLAY DISC +10
RECEIVER SOURCE
1 2 3
4 5 6
7 8 9
0
1 Switch on the playback component.
2 Select the source you want to playback.
Use the MULTI CONTROL buttons on the
remote (or MULTI JOG/INPUT SELECTOR dial
on the front panel).
3 Press STANDARD.
If the source is Dolby Digital, DTS, or Dolby
Surround encoded, the proper decoding format
will automatically be selected and shows in the
display.
XRB3013A.32.37 01.12.12, 4:44 PM 34