Pioneer VSX-D811S - Manual (Page 25)

Connecting up 03
25
En
Receiver
Other Pioneer products
with
Î mark
Operating other Pioneer
components
By connecting a control cord (optional),
you can point the remote controls of other
Pioneer components at the receiver’s
remote sensor. The remote control signals
are received by the remote sensor of this
unit, and sent to the other devices via the
CONTROL OUT terminal.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the
power cord when your hands are wet as this could cause a short circuit or an electric shock. Do not
place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in
the cord or tie it with other cords. The power cords should be routed such that they are not likely to
be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the
power cord once in a while. When you find it damaged, ask your nearest Pioneer authorized service
center or your dealer for a replacement.
Connect to CONTROL
IN terminal of other
Pioneer products
with
Î mark.
Remote
control unit
CONTROL OUT
OUT
IN
CONTROL
AC outlet
[switched 100 W (0.8 A) max]
Power supplied through this outlet is turned on and off by the
receiver's
POWER switch. Total electrical power consumption of
connected equipment should not exceed 100 W (0.8 A).
DO NOT CONNECT A MONITOR, TV SET, HEATER, OR SIMILAR
APPLIANCE TO THIS UNIT'S AC OUTLET.
Do not connect appliances with high power consumption to the
AC OUTLET in order to avoid overheating and fire risk. This can
also cause the receiver to malfunction.
• Make sure no exposed speaker wire is touching the rear panel, this may cause the receiver to
turn off automatically.
• This unit should be disconnected by removing the power plug from the wall socket when not in
regular use (ex. when on vacation).
AC OUTLET
SWITCHED
100 W MAX
0.8 A MAX
XRB3013A.13.25 01.12.12, 4:43 PM 25