Pioneer VSX-D811S - Manual (Page 50)

Controlling the rest of your system 09
50
En
Searching for preset codes
Another way of entering preset codes is to use
the search feature. The remote transmits
batches of 10 codes; when you see the
component you want to control respond (by
turning on or off), you just scan through the last
10 codes until you find the right one.
CHANNEL
ENTER
MPX/RETURN DTV INFO
DTV ON/OFF DTV MENU
D.ACCESS T.EDIT/GUIDE
ST
T P SE U ST
CLASS
FL DIMMER
BAND
TOP MENU AUDIO SUB TITLE
REMOTE SETUP
RECEIVER CONTROL
STANDARD ADV.SURR. STEREO
ANGLE
1 ¡ 4 ¢
7 8 3 ¶
LEVEL
DVD VCR CD-R TV
RCV TUN TVC CD
TEST TONE
CH SELECT
INPUT ATT
INPUT SEL. MUTE MIDNIGHT/ LOUDNESS SIGNAL SEL
MULTI CONTROL
EFFECT DISPLAY DISC +10
RECEIVER SOURCE
1 2 3
4 5 6
7 8 9
0
TUNE
TUNE
ENTER
1 Switch on the component you want to
control.
If the component is some kind of player (CD
player, VCR, etc.), start it playing.
2 Press and hold REMOTE SETUP for three
seconds.
The LED lights steadily for two seconds.
3 Press the MULTI CONTROL button for
the component you want to control.
4 Press and hold REMOTE SETUP for three
seconds.
A batch of 10 codes is transmitted and the LED
blinks during transmission. If the component
responds, by stopping or switching off, go to the
next step, otherwise repeat this step.
5 Switch the component back on or
restart playback.
6 Use ’ and ‘ to scan through the last
10 codes transmitted to identify the correct
code.
Stop when you see the component stop or
switch off. The LCD display on the remote
shows the I.D.
You can also verify you have the correct code by
adjusting the volume, pressing
3, 7, etc.
7 Press and hold ENTER for three seconds
to save the preset code.
Programming signals from
other remote controls
(VSX-D811S only)
If the preset code for your component is not
available, or the available preset codes do not
operate correctly, you can program signals from
the remote control of another component. This
can also be used to program additional
operations (buttons not covered in the presets)
after assigning a preset code.
1 Press REMOTE SETUP and hold for three
seconds.
The LED lights steadily for two seconds.
2 Press the MULTI CONTROL button for
the component you want to control.
3 Prepare the remote to learn the remote
control signal from the component.
Press and hold the RECEIVER button for two
seconds.
The LED lights steadily to indicate the remote is
ready accept a signal.
To exit or cancel press and hold the REMOTE
SETUP key for three seconds.
XRB3013A.49.67 01.12.12, 4:48 PM 50