Pioneer VSX-D811S - Manual (Page 39)

Setting up the receiver 06
39
En
Dynamic range control setting (page 42)
Compress the dynamic range of the sound
track.
Dual mono setting (page 42)
Isolate one channel when listening to discs
with dual mono encoding.
Component video input setting (page
42)
Specify the components to be assigned to
the component video inputs (below).
• Component video 1 input setting
• Component video 2 input setting
Surround back channel input setting
(VSX-D811S only) (page 43)
Specify the number of surround back
inputs you have connected.
Digital input settings (page 43)
Specify the components to be assigned to
the video and digital inputs (below).
• Coaxial digital input 1 setting
• Coaxial digital input 2 setting
• Optical digital input 1 setting
• Optical digital input 2 setting (VSX-D811S
only)
4 Use ’ or ‘ to adjust the setting.
The setting is entered automatically.
5 Repeat steps 3 and 4 to set other
surround modes.
6 When you’re done, press ENTER to exit.
The setting display is automatically exited
after 20 seconds of inactivity.
Speaker setting
• Default setting: S (all speakers)
You must let the receiver know how many
speakers you have, and how big they are. The
size you choose (large or small) determines
how much bass is sent from the receiver to the
speakers.
In the display, F, C, and S refer to front, center,
and surround speakers respectively. Speaker
size is denoted as
L for large speakers, S for
small speakers, and (asterisk) if no speaker is
connected.
• If the cone size (diameter) of the speaker is
larger than 5 inches, set the speaker size
to
L.
• If you’re not using a subwoofer, we
recommend setting the front speakers to L.
• Cycle through the available choices
using ’ or ‘ and choose a configuration
that matches your speaker setup.
One of the following configurations should
match your setup:
FL-CL-SL
FL-CL-SS
FL-CL-S FL-CS-SL
FL-CS-SS
FS-C -SS
FS-CS-S
FS-CS-SS
FL-C -SS
FL-C -SL
FL-CS-S
XRB3013A.38.44 01.12.12, 4:46 PM 39