Printronix L5020 - Manual (Page 182)

Chapter 6 System Status And Error Messages
184
Whether Reprint On Fault Is Enabled, Disabled, Or Confirm:
After a paper jam, you may need to reload the paper onto the
tractors.
Table 4, “Error Messages,” on page 188, designates those errors
that require reprinting to recover from an error condition.
NOTE: Some errors require reprinting, regardless of your printer
configuration. Refer to Table 4 for details.
Procedure For Fault Clearing - Reprint On Fault Disabled
1. A fault occurs.
2. Correct the fault condition.
3. Press CLEAR.
4. The STAND BY LED blinks and the following message appears
while the printer attempts to clear the fault:
If the fault is not cleared:
a. The printer beeps and briefly displays the following
message:
b. The printer then redisplays the original fault message, or
any other uncleared fault message.
c. Attempt to clear the fault condition again, or contact your
service representative.
If the fault is cleared, and if you do not need to reload the paper
into the tractors (for example, the printer ran out of toner):
a. The printer goes OFFLINE.
b. Press ONLINE to resume printing.
Standby...
Clearing Fault
Faults Not Clearing