Patton electronic 1194 - Manual (Page 5)

5
and internal metallic water pipe system, are connected together. This
protection may be particularly important in rural areas.
1.2 FCC INFORMATION
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
1.3 DC POWER NOTICE
Connect the equipment to a 36–60 volts direct-current (VDC), 340 mA
source that is electrically isolated from the AC source. The 36–60 VDC
source
must be connected to a reliable earth ground.
Caution
Users should not attempt to make such connections
themselves, but should contact the appropriate electric
inspection authority, or electrician, as appropriate.
Caution
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous laser radiation exposure.