Patton electronic 1194 - Manual (Page 17)

17
5.0 POWER-UP
To apply power to the Model 1194, first be sure that the unit is connected
to the appropriate power source. Then do the following:
1. Set front panel switches to the center position
2. Plug the provided AC or DC power into the Model 1194.
3. Set the ON/OFF power switch (see Figure 8 on page 16) to ON.
After the local and remote Model 1194s are powered up, a synchro-
nization process will occur to establish a link. The synchronization
process should take approximately 5 seconds. If one of the Model
1194s loses power (for example, during a lightning storm), the local
and remote units will re-synchronize before they can resume data
transmission.