beautypg.com

Planar PR Line PR9020 User Manual

Page 18

background image

16

1.

Make sure that the power cord is firmly and

correctly connected to the projector and the outlet.

Power on/off

Turning on the power

2.

Remove the lens cover, and set the power switch

to the ON position (marked “ I “).

The power indicator will light up in steady orange

(67). Then wait several seconds because the

buttons may not function for these several seconds.

3.

Press the STANDBY/ON button on the projector or

the remote control.

• Turn the power on/off in right order. Please power on the projector prior

to the connected devices. Power off the projector later than the connected devices.

• When the AUTO ON of the OPTION menu is set to the TURN ON, and the power

was turned off by the power switch last time, turning the power switch on makes the

projection lamp light on without pushing the STANDBY/ON button (42).

• Use the shutdown switch (69) only when the projector is not turned off by

normal procedure.

NOTE

Power on/off

The projection lamp will light up and the POWER indicator will begin blinking in green.

When the power is completely on, the indicator will stop blinking and light in steady green.

To display the picture, select an input signal according to the section "Selecting an input signal" (18).

►A strong light is emitted when the projector’s power is on. Do not look into

the lens of the projector or look inside of the projector through any of the projector’s openings.

►Do not touch around the lamp cover and the exhaust vents during use or just after use, since it is too hot.

WARNING

1.

Press the STANDBY/ON button on the projector or the remote control.

The message "Power off?" will appear on the screen for about 5 seconds.

Turning off the power

2.

Press the STANDBY/ON button on the projector or the remote control again while the

message appears.

The projector lamp will go off, and the POWER indicator will begin blinking in orange.

Then the POWER indicator will stop blinking and light in steady orange when the

lamp cooling is complete.

3.

Make sure that the power indicator lights in steady orange, and set the power switch

to the OFF position (marked “O“).

The POWER indicator will go off. Attach the lens cover.

Do not turn the projector on for 10 minutes or more after turning it off. Turning the projector

on again too soon could shorten the lifetime of some consumable parts of the projector.

STANDBY/ON button

POWER indicator

Power

switch