Panasonic TQBH9003-6 - Manual (Page 57)

57
Advanced
Operation
Using the remote terminal
Using the remote terminal built into this projector, it is possible to operate the
projector from an external location from where infrared remote control signals
cannot be received, by using a remote control panel.
Pin assignment and control
Short pin 1 and pin 9 when controlling.
#Power ON/OFF
D-Sub 9-pin (female)
external appearance
NOTE:
B The POWER, RGB and VIDEO buttons on the remote control unit and
projector will not operate when pins 1 and 9 are shorted. RS-232C
commands will also be ignored. If the projector is connecting a personal
computer using an optional wireless card or LAN card, the “POWER” or
“SWITCH INPUT MODE” will not function.
B Do not short pins. 1, 2, 3, 5, or 6 when pin 9 is open. If this is done, the
projector will ignore signals from the remote control unit.
Pin
#
$
%
&
'
(
)
*
+
Signal Name
GND
POWER
INPUT SEL3
INPUT SEL1
INPUT SEL2
ENABLE
Description
Ground
Power ON
Input signal select3
NC
Input signal select1
Input signal select2
NC
NC
Enables remote terminal control
1 5
6 9
Pin No. Setting
Short Open
OFF (standby) ON
$-#
Lamp
Pin No. Setting
Open Open Short Short Short Open
Open Short Open Open Short Open
Open Open Short Open Open Short
RGB1 RGB2 RGB3 VIDEO S-VIDEO DVI
%-#
'-#
(-#
Input Signal
$Switching the input mode