Panasonic TQBH9003-6 - Manual (Page 104)

104
Setting up the projector
Mounting a wireless card
q q Insert the wireless card into the projector
For details of installing and removing the wireless card, refer to "Wireless card" on
page
91 .
w w Press the MENU button to display the menu.
e
e Use and buttons to display
"Network setting" screen.
r r Press the ENTER button to display "Network setting" setting screen.
Status
Five different LAN settings (LAN 1-5) can be stored on the projector.
Selecting from LAN 1-5 with
and buttons, press the ENTER button and its
status will be displayed.
To change the status, choose "RUN" from "Setting Wizard" and press the ENTER
button to move to the LAN setup wizard.
To enable the status, choose "OK" from "Setting Wizard" and press the ENTER
button.
WEP Wired Equivalent Privacy
The projector can encrypt the image data.
However, when the encryption function is enabled, it takes more time to transmit
images.
Selecting from KEY 1-4 with
and buttons, press the ENTER button and the
WEP data will be displayed.
To change the setting of WEP, choose "RUN" from "Setting Wizard" and press the
ENTER button to move to the WEP setup wizard.
To enable the WEP data, choose "OK" from Setting Wizard and press the ENTER
button.
LAN Setup Wizard
IP address
Assign an IP address to the projector.
Make setting according to the typical setting. However, the same IP address as that
of the PC with which the projector communicates cannot be used.
Use
and buttons to change the value, and buttons to switch the
fields. Press the ENTER button when the setting is completed.
Subnet mask
Set the subnet mask of the projector.
Make setting according to the typical setting.
Use
and buttons to change the value, and use and buttons to
switch the fields.
Press the ENTER button when the setting is completed.
NETWORK
STATUS
WEP
LAN1
KEY1
SELECT:[^][@] ENTER:[ENTER]
ESC:[MENU]