Philips 27964-01A - Manual (Page 7)

27964-01A
2
Installation - Pre-Installation Planning
Pre-Installation Planning
Before you begin to assemble your sunbed, you should observe the following consid-
erations.
• The SUNVISION Elite™ 30 and 32
series require a dedicated circuit
capable of providing 30 Amp ser-
vice at 220VAC. This unit must be
hardwired directly to a junction
box. We recommend connection by
a professional electrician.
• IMPORTANT! Voltage must be
below 230V AC or may require a
Buck Booster.
WARNING
Shock hazard.
Disconnect power before
servicing.
Air from the room is used to cool
the sunbed. Maximum ambient
room temperature should be 80°F.
Place your sunbed no closer than
6” from any wall. Make sure nothing
obstructs the airflow into the
sunbed’s endcaps or out of the fan
openings. A poorly ventilated room
may cause the unit to become hot
and cause discomfort to the user.
CAUTION
Use of a voltage source above 230V
AC may prevent proper operation of
the sunbed and could cause damage
and void the warranty.
CAUTION
Proper assembly of your sunbed
requires three people. Plan to have
a couple of helpers assist you.
CAUTION