Philips 27964-01A - Manual (Page 34)

27964-01A
Parts List
This is a list of parts which may be replaced by the
consumer. Care should be taken when replacing
anything related to electrical wiring. We recom-
mend contacting a professional electrician. When
calling for parts, first state your bed model as S-
30SV, S-30SV3F, S-32SV or S-32SV3F, depending
on the model. Then refer to this list and preceding
illustrations for proper part identification.
Acrylic, Bench
Acrylic, Canopy*
Ballast (220VAC, 100W)
Ballast (220VAC, 400W)
Bushing, Bronze 10mm*
Body Fan Kit*
(optional)
Canopy Mounting Arm
Capacitor, 75uF
Contactor (240VAC, 30A)
Cover, Bench
Cover, Canopy
Current Sensor
Endcap, Kit
(with inserts)
Fan, 4” (220VAC, 110cfm)
Gas Spring Cover Panel*
Gas Spring Set*
Handle
Hardware Kit, Complete*
Hardware Kit, Assembly*
Hour Counter*
Ignitor
(Starter for Face Tanner)
Lamp Holder w/ Starter Holder
Lamp Holder w/o Starter Holder
Lamp Holder, Face Tanner*
Lamps*
Pillow*
Record this information for ease of service:
Date of purchase:
Bench serial number:
Canopy serial number:
Profile, Blank*
Remote Connection PCB
Remote Control Bypass Plug*
Schematic Packet*
Silk-screened Profile, English
Silk-screened Profile, French
Skirt Panel
Starter, K-12
(main lamps)
Thermostat* (for face tanner)
Timer, ADI-HT
Timer Keypad, ADI-HT*
Timer Keypad Pushbuttons*
Trim Profile, Gray
Wiring Harness, RJ-11 120”
Wiring Harness, Remote PCB to Timer
(36”)
* Not shown