Philips 27964-01A - Manual (Page 6)

27964-01A
Tools Required
You will need the following tools to
assemble your sunbed.
Utility Knife
#2 Phillips
Screwdriver
7/16” Wrench
1
nstallation
Unpacking and Inspection
Your sunbed comes in two cardboard car-
tons, one for the bench and one for the
canopy. Open the cartons and remove the
bench and canopy as follows.
The bench and canopy are each wrapped
in plastic. Pull back the plastic and, with
a helper, grasp the bench and pull it from
the carton bottom, leaving the plastic
wrap and the carton packaging. Do the
same for the canopy. Do not attempt to
lift either unit with the plastic still on as
it may slip.
Note! The cartons are reusable. You may
wish to save them for future use.
As you unpack your boxes you should
find the following:
• Canopy unit
• Bench unit
• Pair of gas springs
• Front skirt panel
• Bag containing necessary assembly
hardware, safety goggles, opening
handle and pillow
• Gas spring cover panel
Inspect these items, including the canopy
and bench, and make sure they are free
from any visible damage. Report the
extent of any damage to the transportation
company.
Record the serial numbers of the canopy
and bench in the area provided at the
back of this manual. This information will
be required whenever you call customer
service.