Panasonic DP-180 - Manual (Page 175)

175
P
roblem Solv
ing
■ Internet Fax Return Receipt Error Messages
Error messages that are printed on the Internet Fax Return Receipt when remote programming of the Auto Dialler via
email fails.
Error Message Possible Cause
1 Format Error : <@command block, the
"@end" command is missing.> The block termination command "@end" is missing in the
"@command" block, add the "@end" command and try again.
2 Format Error : <@begin block, the "@begin"
command is missing.> The block start command "@begin" is missing in the "@begin" block,
add the "@begin" command and try again.
3 Format Error : <@begin block, the "@end"
command is missing.> The block termination command "@end" is missing in the "@begin"
block, add the "@end" command and try again.
4 Format Error : <@system block, the "@end"
command is missing.> The block termination command "@end" is missing in the "@system"
block, add the "@end" command and try again.
5 Format Error : <@sender block, the "@end"
command is missing.> The block termination command "@end" is missing in the "@sender"
block, add the "@end" command and try again.
6 Format Error : <@domain block, the
"@end" command is missing.> The block termination command "@end" is missing in the "@domain"
block, add the "@end" command and try again.
7 Format Error : <@program block, the
"@end" command is missing.> The block termination command "@end" is missing in the
"@program" block, add the "@end" command and try again.
8 Format Error : <@system block, the
"@system" command is missing.> The system block start command "@system" is missing in the
"@system" block, add the "@system" command and try again.
9 Permission denied : parameter is set to "Valid".> Change the Fax Forward parameter to "Invalid" and try again.
10 Permission denied :
performing a task.>
Try again later when the machine is not busy.
11 Error :
prohibited. Use open ABBR only.>
Cannot overwrite existing programmed data, use the "Delete"
command to erase the existing data first.
12 Permission denied :
incorrect.>
Correct the password and try again.
13 Permission denied :
Update parameter is set to "Invalid".>
Set the Remote Dialler Update parameter to "Valid".
14 Format Error : The format of the Entry is incorrect / incomplete or the data string for
each station is not defined within a single line.
15 Warning : The format of the Entry is incorrect or the number of characters
entered, exceed the maximum allowed in the field. Correct it and try
again.
16 Warning : Field limit exceeded The maximum number of Station Name, Domain Name, Sender
Name, Program Name, etc were exceeded.