Patton electronic 4110 - Manual (Page 21)

SmartNode Series VoIP routers overview 21
Model 4520 & 4110 Series Getting Started Guide 1 • General information
Ports descriptions
The SmartNode 4110 Series rear panel ports are described in
table 4 .
Figure 6. SmartNode 4110 Series power input connectors
Table 4. Rear panel ports
Port Location Description
10/100 Ethernet
ETH 0/0 Rear panel RJ-45 connector (see figure 5 on page 20) that connects the router to an
Ethernet device (a cable or DSL modem, LAN hub or switch, for example).
Voice Ports, FXS Rear panel FXS RJ-11/12 connectors (see figure 5 on page 20) that connect the router
with an FXO port (a telephone for example). EuroPOTS support (ETSI
EG201 188). Configured per model as follows:
• Model 4112—0/0, 0/1
• Model 4114—0/0, 0/1, 0/2, 0/3
• Model 4116—0/0, 0/1, 0/2, 0/3, 0/4, 0/5
• Model 4118—0/0, 0/1, 0/2, 0/3, 0/4, 0/5, 0/6, 0/7
Power Rear panel The gateway is available in a DC or AC power input version (see
figure 6 ), labeled as follows:
• AC version (Internal power supply): 100–240 VAC, 50/60 Hz
• AC version (External power supply): 100–240 VAC, 50/60 Hz
• DC version: 12 VDC
Console Front panel Used for service and maintenance, the Console port (see figure 7 on page 22),
an RS-232 RJ-45 connector, connects the router to a serial terminal such as a PC
or ASCII terminal (also called a dumb terminal).