Patton electronic 4110 - Manual (Page 18)

1 • General information Model 4520 & 4110 Series Getting Started Guide
18 SmartNode Series VoIP routers overview
Figure 3. SmartNode 4520 Series power input connectors
Ports descriptions
The SmartNode 4520 Series rear panel ports are described in
table 3 .
Table 3. Rear panel ports
Port Location Description
10/100 Ethernet
ETH 0/0 & ETH 0/1 Rear panel RJ-45 connectors (see figure 2 on page 17) that connect the router to an Ether-
net device (e.g., a cable or DSL modem, LAN hub or switch).
Voice Ports, FXS Rear panel FXS RJ-11/12 connectors (see figure 2 on page 17) that connect the router
with an FXO port (a telephone for example). EuroPOTS support (ETSI
EG201 188). Configured per model as follows:
• SmartNode 4522—0/0, 0/1
• SmartNode 4524—0/0, 0/1, 0/2, 0/3
• SmartNode 4526—0/0, 0/1, 0/2, 0/3, 0/4, 0/5
• SmartNode 4528—0/0, 0/1, 0/2, 0/3, 0/4, 0/5, 0/6, 0/7
Power Rear panel The gateway is available in a DC or AC power input version (see
figure 3 ), labeled as follows:
• AC version (Internal power supply): 100–240 VAC, 50/60 Hz
• AC version (External power supply): 100–240 VAC, 50/60 Hz
• DC version: 12 VDC
Console Front panel Used for service and maintenance, the Console port (see figure 4 on page 19),
an RS-232 RJ-45 connector, connects the router to a serial terminal such as a PC
or ASCII terminal (also called a dumb terminal).