Pelican TH-50VX100U - Manual (Page 9)

1 2
SERIAL PC IN
AUDIO
SLOT1 SLOT2 SLOT3
COMPONENT/RGB IN
AUDIO R L P R /C R /R P B /C B /B Y/G
1
2
1
2
1
2
9
Connections
– Cable fixing band
Secure any excess cables with band as required.
Note:
Make sure that the AC
cord is locked on both
the left and right sides.
Push until
the hook
clicks.
1. Keep the
knob pressed.
Close
Open
1 Plug the AC cord into
the display unit.
Plug the AC cord until it
clicks.
2 Fix the AC cord with
the clamper which is
attached to the unit.
Note:
One fixing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Speaker
terminal (R)
Speaker
terminal (L)
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
Pass the attached cable
fixing band through the
clip as shown in the
figure. To secure cables connected to Terminals, wrap the cable fixing band around them
then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially
in the power cord), firmly bind all cables with the supplied fixing band.
From SERIAL
Terminal on
Computer
(see page 11)
From EXTERNAL
monitor terminal
on Computer
(see page 10)
AC cord connection (see page 13)
Dual HDMI Terminals (equivalent
of Dual HDMI Terminal Board
(TY-FB10HMD))
(see page 12)
To tighten:
To loosen:
Pull
Pull
Push the catch
Note: At factory shipment, Terminal boards are installed in SLOT 1, SLOT 2 and SLOT 3.
– AC cord fixing
COMPONENT/RGB IN and
Audio IN Terminals (equivalent
of RCA Component Video
Terminal Board (TY-42TM6Z))
(see page 12)
Unplug the AC cord
Unplug the AC
cord pressing the
two knobs.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug at
the socket outlet first.
2. Pull off.