Pelican TH-50VX100U - Manual (Page 34)

34
Do not display a still picture, especially in 4:3 mode, for any length of time.
If the display must remain on, a SCREENSAVER should be used.
SCREENSAVER
(For preventing image retention)
1 Display the menu screen.
2 Select “SET UP”.
SET UP
POS. /SIZE
SOUND
PICTURE
2 OK
1 select
3 Select “SCREENSAVER”.
COMPONENT/RGB-IN SELECT
EXTERNAL SCALER MODE
POWER SAVE
STANDBY SAVE
POWER MANAGEMENT
OFF
ON
OFF
OFF
RGB
SCREENSAVER
SIGNAL
2 OK
1 select
4
FUNCTION selection
Select “FUNCTION” and select the
desired function.
OFF
OFF
BRIGHT SIDE BAR ADJUST
SCREENSAVER
START
WOBBLING
PEAK LIMIT
FUNCTION NEGATIVE IMAGE
2
change
1 select
SCROLLING BAR ONLY
OVERLAY SCROLLING BAR
NEGATIVE IMAGE
WHITE SCREEN
NEGATIVE IMAGE : A negative image will be displayed on the screen.
SCROLLING BAR ONLY: A white bar will scroll from left to right. The image
won’t be displayed.
OVERLAY SCROLLING BAR: The brightness of the image will be decreased
and a white bar will scroll on it.
WHITE SCREEN : The whole screen will be white.
5
START setting
Select “START”.
NEGATIVE IMAGE
OFF
OFF
BRIGHT SIDE BAR ADJUST
SCREENSAVER
START
WOBBLING
PEAK LIMIT
FUNCTION
1 select
2 OK
The menu screen will disappear and the SCREENSAVER will be activated.
To stop the SCREENSAVER under ON, press
or any buttons on the
main unit.
Note: When the display is turned off, the SCREENSAVER will be deactivated.
OFF
OFF
BRIGHT SIDE BAR ADJUST
SCREENSAVER
START
WOBBLING
PEAK LIMIT
FUNCTION NEGATIVE IMAGE