Pelican TH-50VX100U - Manual (Page 41)

33.7 kHz
60.0 Hz
1125(1080)/60i H-FREQ.
V-FREQ.
SIGNAL FORMAT
33.7 kHz
60.0 Hz
1125(1080)/60i
H-FREQ.
V-FREQ.
108.0 MHz DOT CLOCK-FREQ.
SIGNAL FORMAT
41
SET UP for Input Signals
Select SIGNAL from the “SET UP” menu during RGB input signal.
SYNC
Setting RGB sync signal
Confirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT signal)
AUTO: The H and V sync or synchronized signal are automatically selected. If both input, it is selected the H and V
sync.
ON G: Uses a synchronized signal on the Video G signal, which is input from the G connector.
VBS: Uses a synchronized signal of Composite Sync input, which is input from the HD connector.
Displays the frequency and the type of the current input signal.
This display is valid only for COMPONENT/RGB/PC and Digital input signal.
Display range:
Horizontal 15 - 110 kHz
Vertical
48 - 120 Hz
Input signal display
The dot clock frequency is displayed during digital signal input.
Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).
Note:
Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board (TY-FB11DHD)
is selected.
SDI THROUGH
AUTO SYNC
1024 ×768 XGA MODE
100 Hz REFRESH RATE
SIGNAL [ RGB ]
2 change
1 select
AUTO VBS ON G
SIGNAL [ Digital ]
OFF SDI THROUGH
100 Hz REFRESH RATE
2 change
1 select
ON OFF
ON: Enables active through.
OFF: Disables active through.