beautypg.com

Changing a password – PACKARD BELL TM87 User Manual

Page 39

background image

Chapter 2

29

Changing a Password

1. Use the ↑ and ↓ keys to highlight the Set Supervisor Password parameter and press the Enter key. The

Set Password box appears.

2. Type the current password in the Enter Current Password field and press Enter.
3. Type a password in the Enter New Password field. Retype the password in the Confirm New Password

field.

4. Press Enter. After setting the password, the computer sets the User Password parameter to “Set”.
5. If desired, you can enable the Password on boot parameter.
6. When you are done, press F10 to save the changes and exit the BIOS Setup Utility.
If the verification is OK, the screen will display as following.

The password setting is complete after the user presses

Enter.

If the current password entered does not match the actual current password, the screen will show you the

Setup Warning.

If the new password and confirm new password strings do not match, the screen will display the following

message.

Set Supervisor Password

Enter Current Password [ ]

[ ]

Enter New Password [ ]

Confirm New Password [ ]

[ ]

Setup Notice

Changes have been saved.

[Continue]

[

Continue

]

Setup Warning

Invalid Password.

[Continue]

[

Continue

]

Setup Warning

Passwords do not match.

Re-enter password.

[Continue]

[

Continue

]

This manual is related to the following products: