Panasonic DBS 824 - Manual (Page 131)

Intercom Calling Key Telephone Features
3-44 DBS 824-3.0/3.2-700 Revised April 2000
Voice Calling. With voice calling, intercom calls are connected immediately,
without a ringing tone.
Tone Calling. With tone calls, a ringing tone is sent to the called extension.
System programming determines whether the DBS 824 uses voice or tone
calling as a default. If voice calling is the default, dialing “1” after the
extension number changes the call to a tone call. If tone calling is the default,
dialing “1” results in a voice call.
Operation
To make a Voice Call:
1. Pick up the handset.
The phone issues intercom dial tone.
Note: If you are calling from an extension programmed for Prime Line
Preference, press the FF key programmed for intercom operation.
2. Dial the extension number (10-69) or (100-699).
3. If the system default is tone calling, dial “1.”
• “Talk-EXT XXX” (where “XXX” is the extension) appears on the
display. If the extension name has been stored, that name appears on
the display after “Talk” instead of “-EXT XX.”
• The EXT LED lights.
4. Complete the call and replace the handset.
The EXT LED goes off.
To transfer a call using Voice Calling:
1. Press the HOLD key.
• The EXT LED flashes.
• “Hold-EXT XXX” (where “XXX” is the extension) appears on the
display.
2. Dial the number of the extension to which the call will be transferred.
3. If the system default is tone calling, dial “1.”