Pioneer FH-P9200MP - Manual (Page 49)

M HPF: 31.540506380100125
160200 (Hz)
M LPF: 1.622.53.15456.38
1012.516 (kHz)
H HPF: 1.622.53.15456.38
1012.516 (kHz)
4 Press a or b to adjust the level of the
selected speaker unit (filter).
Each press of a or b increases or decreases
the level of the selected speaker unit (filter).
0dB 24dB is displayed as the levelis in-
creased or decreased.
+6dB 24dB is displayed as the levelis in-
creased or decreased, only if you haveselected
L LPF.
5 Press SLOPE to select the slope of the
selected speaker unit (filter).
L LPF: 12 18 6 (dB/oct.)
M HPF: 12 18Pass (0) 6 (dB/oct.)
M LPF: 12Pass (0) 6 (dB/oct.)
H HPF: 12 6 (dB/oct.)
6 Press PHASE to switch the phase of the
selected speaker unit (filter).
Each press of PHASE switches the phase be-
tween normal and reverse .
# You can adjust the parameters for other
speaker units (filters) in the same way.
7 Press BAND to cancel the network ad-
justment mode.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to this unit, turn the sub-
woofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1 Press AUDIO and NEXT and then press
SW1 to select the subwoofer output mode.
# SW2 is displayed only when the subwoofer
output is on in the subwoofer output mode
(SW1).
2Press SW1 to turn subwoofer output
on.
SUB.W ON appears in the display. Subwoofer
output is now on.
# To turn subwoofer output off, press SW1
again.
3 Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase. Press d to se-
lect normal phase.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press AUDIO and NEXT and then press
SW2to select the subwoofer setting mode.
2Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
506380100125 (Hz)
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
3 Press a or b to adjust the output level
of the subwoofer.
Each press of a or b increases or decreases
the level of the subwoofer. +6 24 is dis-
played as the level is increased or
decreased.
Audio Adjustments
En
49
English
Section
11