Philips cSmart Series - Manual (Page 9)

To Raise:
•
Keep both adjusters (A) pressed and lift to raise the projector.
– The projector feet (B) will come out.
To Lower:
•
Keep both adjusters (A) pressed and gently lower the
projector.
• Use the Focus Ring and Zoom Ring to readjust the focus and
size of the image.
Horizontal angle (horizon)
•
Adjust or correct a possible tilted picture by turning the
projector feet to the desired position.
Up: turn the feet to the left.
Down: turn the feet to the right.
• Use the Focus Ring and Zoom Ring to readjust the focus and
size of the image.
Keystone correction
If projector and screen are not properly placed, the picture will be
distorted, producing a keystone image.
Keystone correction allows you to correct
picture distortion of the vertical keystone type
by internal scaling.
• Use the Keystone button to widen the image.
• Use the Keystone button to narrow the image.
• This correction function also is accessible through the
‘Keystone Correction’ option in the ‘Settings’ menu of the On
Screen Display (OSD) menu.
Moving the projector
1. Press the Stand by On button to put the projector in stand by.
The standby indicator lights up red.
2. Wait until the cooling fan has stopped (about 3 minutes after
the projector has been switched off) and disconnect the mains
lead and all other cables.
3. Put the lens cap back in place to prevent dust, dirt or other
contamination from harming or damaging the front of the
projector lens when moving the projector.
Note: Never place the projector on the side where the
connections are located.
Transporting the projector
The projector contains many glass and precision parts. If you need
to transport the projector, please follow these packing instructions
to pervent accidental damage to the projector.
• When transporting the projector for repair, use the original
packaging material if possible. If you do not have the original
packaging, use equivalent materials, placing plenty of
cushioning around the projector.
• When transporting the projector as freight or checked luggage,
first put it in a carrying case (such as the soft bag supplied),
then pack it in a firm box, using cushioning around the case.
• When you are hand-carrying the projector, be sure to use a
carrying case (such as the soft bag supplied).
Inserting the batteries in the remote control
1. Push and slide the lid in the direction of the arrow.
2. Install two ‘AAA’ batteries as indicated inside the battery
compartment.
3. Replace the lid and snap it into place.
Note: The maximum range of the remote control is approximately
15 m (± 50 feet).
P u s h
Me nu
OK
A V Mu te
Ke ys to ne V o lu me
St an d by
La mp RC
Keystoned Image
6. Set Up
9