Resetting the lamplife time, Maintenance – Philips cSmart Series User Manual

Page 22

7. Grasp the lamp holder handle and carefully pull the lamp

holder out of the projector.

8. Carefully remove the new lamp housing from its package. Do

not touch lamp or point lamp housing opening at anyone. Do
not drop, as the impact may cause the lamp to break.

9. Place the lamp holder in the guiding slots and insert into the

lamp compartment.

10. Tighten the screws.
11. Replace the cover and tighten the screws.
12. Plug the projector back in by inserting the mains lead in the

Mains socket.

13. Press the Stand by On button to switch on the projector.
14. Reset the lamp life time (see ‘Resetting the lamplife time’).
15. Properly dispose of the old lamp.

Notes:

–

When replacing the lamp, always use the same type of lamp
LCA3115/00, 12NC 8670 931 15009).

–

Please dispose of lamp in special chemical disposal bins.

Resetting the lamplife time

1. Press Menu.
–

The menu bar appears on the screen.

2. Use cursor control to

select Settings in the
menu bar.

3. Use cursor control to

select Lamp counter in
the sub menu.

4. Press OK for 3 seconds to reset the lamp counter.
5. If required, select another item you wish to adjust or press

Menu to exit.

Display

Language

Keystone correction

Start-up screen

Lamp counter

System informatyion...

Factory reset

(more)

Lamp

0 hours

Lamp counter shows the operating hours of the

lamp. It is suggested to reset when a new lamp is

inserted. To reset keep OK key pressed

for 3 seconds.

Picture

Audio

Settings

Projector

2453 hours