Philips LaserMFD LFF 6050 - Manual (Page 41)

LFF6050
- 36 -
6 - Parameters/Setup
Printing the functions guide
51 - PRINT / FUNCTIONS LIST
Press , enter 51 using the keypad.
The printing of the functions guide starts.
Printing the logs
The incoming and outgoing logs list the last 30
transmissions (incoming and outgoing) made by your
machine.
An automatic print out will take place after every 30
transmissions. However, you may request a print out at
any time.
Each log (incoming or outgoing) contains a table with the
following information:
• date and time of the incoming or outgoing document,
• subscriber’s number or E-mail address,
• transmission mode (Normal, Fine, SFine or Photo),
• number of pages sent or received,
• call duration,
• incoming or outgoing results: noted CORRECT if
properly transmitted,
or
information codes for special calls (polling, manual
subscribers, etc.)
• reason for call error (example: your subscriber does
not answer).
To print the logs:
54 - PRINT / LOGS
Press , enter 54 using the keypad.
The printing of the logs starts. The incoming and outgoing
logs are printed on the same page.
11 - RX speed Transmission speed for incoming
documents.
For a quality telephone line
(compatible, no echo),
communications occur at
maximum speed.
However, it may be necessary to
restrict the transmission speed for
some calls.
12 - Rings Number of rings to automatically
start your machine.
13 - Discard size The Discard Size parameter only
defines the printing of received
faxes. The number of lines of a
document can be too high for the
printing paper format. This
parameter defines the threshold
beyond which the extra lines are
printed on a second page. Below
this threshold, extras lines are
deleted.
If you choose ON, the threshold is
set on 3 centimeters.
If you choose OFF, the threshold is
set on 1 centimeter.
20 - E.C.M. This parameter helps correct the
calls made on disturbed telephone
lines. It is used when the lines are
weak or too noisy. Transmission
times may be longer.
25 - TEL Impedance This parameter lets you choose
between a complex impedance
and a 600 Ohm impedance,
depending on the telephone
network your terminal is connected
to.
80 - Toner save Makes printing lighter to save toner
cartridge ink.
90 - RAW Port RAW network print port
connection.
91 - Printer error
timeout Time-out before document being
printed is deleted following a print
error in PC print mode.
92 - Printer wait
timeout Wait time-out for data from PC
before the task is deleted in PC
print.
93 - Replace format Page format change. This
parameter allows you to print a
LETTER format document on A4
pages using the LETTER/A4
setting.
96 - NBR. WEP
Keys Number of WEP keys allowed
(from 1 to 4).
Parameter Signification
Important
The printing is not possible on A5
(or Statement) paper format.
Note
You can also access the PRINT menu
by pressing the button.
Important
The printing is not possible on A5
(or Statement) paper format.
Note
You can also access the PRINT menu
by pressing the button.