Polaris 120 XC SP - Manual (Page 79)

A--60
MAINTENANCE
Track Inspection
Using a hoist or jackstand,
safely lift and support the
rear of the snowmobile off
the ground. Rotate the track
by hand to check for any
possible damage.
To inspect track rods,
carefully examine the track
along the entire length of
each rod, bending the track
and inspecting for breakage.
The three most common
places where breakage
occurs are shown in the
illustration.
Check the track clips and
tighten if loose.
If any rod damage is found,
the track should be replaced.
NOTE: The 120 XC SP track has molded in track clips. It is common
for a thin layer of rubber to detach from clip area and peel off during
initial use.
Never make this maintenance check with the engine running, as
serious personal injury can result.
WARNING
2 1 3 1 2
Track window Lug
Serious personal injury or death may occur. Broken track rods are
a serious hazard, since they can cause a rotating track to come off
the machine. Never operate or rotate a torn or damaged track
under power.
WARNING