Linksys EtherFast 10/100 Network In a Box FENSK05 - Manual (Page 50)

Setting Up Your EtherFast LAN Card for Wake-
On-LAN Use
1. Use the diagram below to locate the WOL pins and
the jumpers on the EtherFast LAN Card.
2. Connect one end of the 3-pin Wake-On-LAN wire to
the EtherFast LAN Card.
3. Now you need to set the jumpers on your card
according to whether your motherboard supports RWU-
high, RWU-low, or PME. Keep in mind that the jumpers
are numbered backwards: the numbers read right to left
and down to up.
If your motherboard supports Remote Wake-Up High
(RWU-high), set your jumpers like this:
If your motherboard supports Remote Wake-Up Low
(RMU-low), set your jumpers like this:
If your motherboard supports Power Management
Event (PME), set your jumpers like this:
48
Wake-On-LAN