Linksys EtherFast 10/100 Network In a Box FENSK05 - Manual (Page 13)

Windows 98 Setup
After installing the EtherFast hardware in your comput-
er, follow these instructions for installing the network
driver. The installation procedure for the network driver
will vary slightly depending on the version of Windows
98 you are using and your current system configuration.
If at any time during the installation you encounter
problems, consult the Troubleshooting section on page
55 of this guide.
To install the network driver:
1. Start up your computer and Windows 98.
2. Windows 98 will automatically detect the presence of
the PCI Ethernet Card hardware in your computer.
3. While the Update Device Driver Wizard window is
visible, put the EtherFast Card program disk 1 into drive
A and click on Next.
4. The following window will appear, select "Search for
the best driver for your device (Recommended).” Click
on Next.
11
Windows 98