LevelOne WBR-6005 User Manual

Page 65

11n only: Only 802.11n clients will be able to communicate with
the Wireless Router (up to 150 Mbps).

■

11g/n mixed: Both 802.11g and 802.11n clients can communicate
with the Wireless Router (up to 150 Mbps), but data transmission

rates may be slowed to compensate for 802.11g clients.

■

11b/g/n Mixed: All 802.11b/g/n clients can communicate with the
Wireless Router (up to 150 Mbps), but data transmission rates may

be slowed to compensate for 802.11b/g clients.

■

◆

Network Name (SSID) — The name of the wireless network service
provided by the Wireless Router. Clients that want to connect to the

network must set their SSID to the same as that of the Wireless Router.

(Default: ―LevelOne‖; Range: 1-32 characters)

◆

Multiple SSID1 — One additional VAP interface supported on the
device. (Default: no name configured; Range: 1-32 characters)

◆

Broadcast Network Name (SSID) — By default, the Wireless Router
always broadcasts the SSID in its beacon signal. Disabling the SSID

broadcast increases security of the network because wireless clients

need to already know the SSID before attempting to connect. When set

to disable, the Network Name SSID, and SSID1 are automatically set to

―Hide.‖ (Default: Enabled)

◆

AP Isolation — The Wireless Router will isolate communincation
between all clients in order to protect them. Normally for users who are

at hotspots. (Default: Disabled)

◆

MBSSID AP Isolation — The Wireless Router will isolate wireless
clients from different SSID.

◆

BSSID — The identifier (MAC address) of the Wireless Router in the
Basic Service Set (BSS) network.

◆

Frequency (Channel) — The radio channel that the Wireless Router
uses to communicate with wireless clients. When multiple access points

are deployed in the same area, set the channel on neighboring access

points at least five channels apart to avoid interference with each other.

For example, you can deploy up to three access points in the same area

using channels 1, 6, 11. Note that wireless clients automatically set the

channel to the same as that used by the Wireless Router to which it is

linked. Selecting Auto Select enables the Wireless Router to

automatically select an unoccupied radio channel. (Default: AutoSelect)

– 65 –

HAPTER

| Wireless Configuration

Basic Settings